Or 4T Trigger Mode Settings (Sth Models) - Miller Electric Si 160 Owner's Manual

4-11. 2T Or 4T Trigger Mode Settings (STH Models)
4
3
2
1
Current (A)
Remote 2T Trigger Operation
Main Amps
Preflow
P
Current (A)
Initial Slope
Initial Amps
Preflow
P
R
OM-250 147 Page 22
5 6
Final Slope
Postflow
R
Remote 4T Trigger Operation
Main Amps
P
7
Time
Final Slope
Final Amps
Postflow
Time
R
1 Process/Set-Up Selector
Switch
2 TIG HF Start
3 TIG Lift Arc Start Light (LED)
4 Ready Light (LED)
5 Set-Up Light (LED)
6 Ammeter And Parameter
Display (Meter)
7 Amperage/Set-Up Adjustment
Control
2T and 4T are used with the TIG
process. Select TIG process ac-
cording to Section 4-9.
.
Unit will automatically exit the
set-up menu if no activity is de-
tected for more than three
seconds. Press and hold Pro-
cess/Set-Up Adjustment con-
trol to re-enter set-up mode.
While in the set-up mode, to change
between 2T and 4T proceed as fol-
lows:
Press and hold the Process/Set-Up
Selector switch until Set-Up light
begins to flash and meter displays
2T.
Rotate Amperage/Set-Up Adjust-
ment control to switch between 2T
and 4t.