Table of Contents
Advertisement
Field
Dynamic Route
Direction
Multicast
IPv6 Address
DHCP IPv6
Enable
DHCP PD Enable
MLD Proxy
Dual Stack Lite
Enable
Select Static IP Address in the ISP encapsulation to set static IP information.
You will need to enter the Connection type, IP address, subnet mask and
gateway address provided by your ISP. Each IP address entered must be in the
Select this option to specify the Routing Information
protocol (RIP) version. You can select RIP1, RIP2-B or
RIP2-M.
You can select None, Both, IN Only or OUT Only to
specify the RIP direction. None is for disabling the
RIP function. Both means the ADSL Router will
periodically send routing information and accept
routing information then incorporate into routing
table. IN only means the ADLS router will only
accept but will not send RIP packets. OUT only
means the ADLS router will only send but not accept
RIP packets.
IGMP (Internet Group Multicast Protocol) is a
session-layer protocol used to establish membership
in a multicast group. The ADSL Router supports both
IGMP version 1 (IGMP v1) and IGMP version 2 (IGMP
v2). Select Disabled to disable it.
Provide address assignment to hosts to include
DHCP in local pools. You can choose DHCP or SLAAC.
IPv6 Prefix Delegation Options for DHCPv6. You may
enable or disable DHCP PD.
You may enable or disable MLD Proxy. Mld proxy is
enabled only for route mode. It works in an IPv6
environment.
You may Enable or Disable Dual Stack Lite. The ADSL
Router support IPv4/v6 Dual Stack Internet Protocol.
51
Description
Advertisement
Table of Contents
