GE SX TRANSISTOR CONTROL IC3645SR4U404N2 Installation And Operation Manual page 45

DIAGNOSTIC STATUS CODES
SX TRANSISTOR CONTROL
TRACTION
STATUS CODE
Maintenance alert and speed limit.
-99
MEMORY RECALL
YES
SYMPTOM
Status code is displayed for 4 seconds when the
Circuits valid
key switch is first turned on, and/or the vehicle
may run at a reduced speed.
for
Traction
CUSTOMER SELECTED SETTING WITH THE
Controller HANDSET:
User defined status code is displayed when the
normal hour meter reading exceeds the
programmed "maintenance alert hours" setting
selected by the user
= Maintenance Code Hour Meter, Functions 19
and 20, are programmed with the Handset and
command the display of status code -99.
= If desired, Maintenance Code Speed Limit,
Function 13, can be programmed with the
Handset.
User should perform the desired maintenance
function. Re-set maintenance alert hour meter
after maintenance is performed.
DESCRIPTION OF STATUS
CORRECTIVE ACTIONS
CAUSE OF STATUS INDICATION
This status code will be displayed when the "normal"
hour meter exceeds the "maintenance alert hours"
setting for the vehicle.
TROUBLE-SHOOTING DIAGRAM
NO DIAGRAM
USER SHOULD PERFORM THE DESIRED
MAINTENANCE FUNCTION
Page 45
January 2000