INSTALLATION AND OPERATION MANUAL
IT/IP TRANSISTOR CONTROL
Section 7. DASH DISPLAYS
Section 7.1 Application
The SX family Standard and Interactive Dash Displays
allow the operator and maintenance personnel easy
access to truck operation information and real-time system
diagnostics of the controller, motor and various
accessories. Hourmeter readings, battery discharge
information, maintenance information and system status
codes are clearly displayed during startup and running
modes. Shielded cable connections are made to the Dash
Display by means of five (5) 22-gage wires to the "Y" Plug
of the traction and hydraulic pump controls.
Section 7.2 Standard Dash Displays
GE Electric Vehicle
Motors & Controls
The GE Standard Dash Display is a four segment Light
Emitting Diode (LED) instrument that displays the GE LX, ZX,
and SX Status Codes, Hourmeter Readings, Battery
Discharge Indication, and Maintenance Required Code.
The four LED's above the symbols indicate the active
Section 7.3 Interactive Custom Dash Displays
The Interactive Custom Dash Display allows the operator to
select the best vehicle performance for changing factory
(task) conditions. There are four (4) "operator interaction
modes" that can be selected by depressing a push-button
on the dash display.
From the Dash Display, the operator may select any of four
pre-set interactive modes consisting of (4) Controlled
Acceleration levels, (4) Field Weakening Pick Up levels and
(4) Speed Limit levels.
These interactive modes are "pre-set" using the Handset
(Functions 48 - 63) or a personal computer (Functions 97 -
112). This feature allows the operator to select the best
vehicle performance for changing factory (task) conditions.
The Custom Dash Display incorporates all the features and
functions of the Standard Dash Display, in addition to the
following customer options:
= LED graphics to display Battery Discharge Indication
= Various LED indicators for Maintenance Required Status
Codes. These can include options for traction, pump and
power steer motors, hourmeter, over-temperature, seat
belt, brake and other safety sensors.
= A push-button associated with the four segment LED that
displays Status Codes can be used to scroll the last 16
"Stored Status Codes" that shut down vehicle operation
with a PMT fault.
Connections are made to the Dash Display with five (5) 22-
gage wires to Plug "Y" of each control. Shielded cable is
required to eliminate signal interference.
P=Traction & Pump
3=Round Face with four
For Custom Dash Displays,
contact your vehicleOEM.
AMP#1-87195-8 Dash Display mating pin
Dash Display mating plug
Dash Display plug kit
"Y" Plug receptacle