One-Pass Scan For Multiple Scan Jobs - Microtek ScanWizard Medi Reference Manual

One-pass Scan for Multiple Scan Jobs

If this option is unchecked, when you assign multiple scan jobs in the preview
window, the scanner will continuously scan for several passes, depending on the
number of scan jobs that are selected. For instance, assuming that there are
three scan jobs selected, the scanner performs the first job, and as the scanner
carriage returns to the stand-by position, the scan for the second job begins, and
so forth to the third job — for a total of three passes. More scan jobs there are,
the longer the scanner time will be.
If this option is checked, the scanner performs scanning in a single pass for all
the selected scan jobs. The scanner' s carriage moves only once and when it
returns to the stand-by position, ScanWizard Medi then starts to process and
finish all of the scan jobs.
Note: This function will be carried out automatically once you apply the Smart-Scan
button on your scan; therefore, there is no need to check this option from Scan Job
Queue window when you are scanning X-ray films (positive films).
To use the "One-pass Scan for Multiple Jobs", the image original should meet the
following conditions:
1. For all the scan jobs, the "resolution x scale" value in the Settings window
should be the same.
2. All the scan jobs should have the same scan type.
3. If the screen filter is applied, all the scan jobs should use the same descreen
lpi value.
If ScanWizard Medi has detected that your image original does not meet the
above conditions, the "One-pass Scan for Multiple Jobs" option is dimmed and
will not be available for selection.
Microtek ScanWizard Medi Reference Manual 69