The number of the module at the top of the list flashes to
show it is highlighted. Push to move the highlight to
the next module in the list.
The Product stays in the module selection mode for
approximately 2 minutes. To select a module to bind to
the Product:
1.
Push until you highlight the module to bind.
Note
The radio button () on the module highlighted
in the list flashes at a faster rate. This helps
identify the highlighted module.
2.
Push . The number of the selected module will
change to a grey number on a black background.
See Figure 9.
3.
Do steps 1 and 2 again for each module to bind to
the Product. The Product can bind to a maximum of
three modules.
4.
You can wait for the module selection time to
complete or push and hold for 2 seconds to end
the module selection mode.
Shop for Fluke products online at:
MyFlukeStore
www.
.com
Wireless Multimeter
Remote Operation
Auto
V AC
120.0
T3000
1
V3000
2
Auto
V AC
120.0
T3000
1
V3000
2
Hold 2 Seconds
Auto
V AC
120.0
21
1
°C
Figure 9. Module Binding Procedure
1.877.766.5412
gxr013.eps
27