Making Espresso Coffee Using Coffee Beans; Making Coffee Using Pre-Ground Coffee; Making Drinks With Milk; Filling And Attaching The Milk Container - DeLonghi ESAM6620 Owner's Manual

Danger of burns!
During rinsing, a little hot water flows from the
coffee spouts and is collected in the drip tray.
Avoid contact with splashes of water.

Making espresso coffee using coffee beans

Important!
Do not use caramelised or candied coffee beans
as they could stick to the coffee grinder and
make it unusable.
1. Fill the container with coffee beans (fig. 8).
2. Place under the coffee spouts:
- 1 cup if you want 1 coffee (fig. 9);
- 2 cups, if you want 2 coffees (fig. 10);
3. Lower the spouts as near as possible to the
cup. This makes a creamier coffee (fig. 11).
4. Press the button corresponding to the
number of coffees required (one cup
or two cups
5. Preparation begins.
Once the coffee has been made, the appliance is
ready to use again.
Please note:
• While the machine is making coffee, delivery
can be interrupted at any moment by pressing
one of the coffee buttons.
• At the end of delivery, to increase the quantity
of coffee in the cup, just press (within 3
seconds) one of the coffee buttons until the
required quantity has been reached.
Please note: Tips
For hotter coffee, you should:
1) perform a rinse cycle as described in the
section "Manual rinsing".
2) before making coffee, warm the cups by rinsing
them with hot water (using the hot water
function).
Important!
If the coffee is delivered a drop at a time, too fast
and not creamy enough or too cold, read the tips
in the "Troubleshooting" section on page 21.

Making coffee using pre-ground coffee

Important!
• Never add pre-ground coffee when the
machine is off or it could spread through the
inside of the machine and dirty it. This could
) (fig. 12).
damage the appliance.
• Never use more than one level measure or it
could dirty the inside of the machine or block
the funnel.
Please note:
If you use pre-ground coffee, you can only make
one cup of coffee at a time.
1. Press the
until "PRE-GROUND" flashes on the display.
2. Put one level measure of pre-ground coffee
into the funnel (fig. 13).
3. Place a cup under the coffee spouts.
4. Press the 1 cup
5. Preparation begins.
After using the machine with pre-ground coffee,
to go back to making coffee using beans,
deactivate the pre-ground coffee function by
pressing the
coffee grinder.

MAKING DRINKS WITh MILK

Filling and attaching the milk container

1. Turn the lid of the milk container clockwise
until it becomes noticeably difficult to turn,
then remove (fig. 14).
2. Fill the milk container with a sufficient
quantity of milk, not exceeding the MAX level
marked on the handle (fig. 15).
Please note:
For a richer dense froth, use skimmed or partially
skimmed milk at refrigerator temperature
(about 5°C). To avoid milk with poor froth or
large bubbles, always clean the milk container
as described in the section "Cleaning the milk
container".
3. Make sure the milk intake tube is correctly
inserted in the bottom of the milk container
lid (fig. 16).
4. Replace the milk container lid and turn
anticlockwise as far as it will go.
5. Remove the hot water spout from the nozzle
(fig. 17).
6. Attach the container to the nozzle and push
as far as it will go (fig. 18). The machine
emits a beep (if the beep function is active).
7. Place a sufficiently large cup under the coffee
spouts and frothed milk spout.
14
button (fig. 2) repeatedly
or button (fig. 12).
button again to enable the