Yamaha YZ125(P)/LC Owner's Service Manual page 118

L Pass the radiater breather
hose and CDI magneto
lead between the frame and
radiator.
M Align the top of the brake hose
neck with the brake hose
holder bottom.
N Pass the brake hose in front
of the axle boss, then fit it
into the hose groove so that
the brake hose does not
contact the nut (wheel axle).
O Fit the brake hose into the
guide on the protector.
P Position each lead at the lower
left of the main tube (frame)
and put the clamp ends within
the area as shown by the
arrow.
CABLE ROUTING DIAGRAM
2-14
SPEC