Table of Contents
Advertisement
PERIODIC MAINTENANCE AND MINOR REPAIR
1. Axle nut
2. Washer
3. Locknut
4. Drive chain slack adjusting bolt
5. Push the wheel forward, and then
remove the drive chain from the
6
rear sprocket.
NOTE:
G
If the drive chain is difficult to re-
move, remove the wheel axle first,
and then lift the wheel upward
enough to remove the drive chain
from the rear sprocket.
G
The drive chain cannot be disas-
sembled.
6. While supporting the brake caliper
and slightly lifting the wheel, pull
the wheel axle out.
1. Wheel axle
NOTE:
A rubber mallet may be useful to tap the
wheel axle out.
7. Remove the wheel.
CAUTION:
Do not apply the brake after the
wheel has been removed together
with the brake disc, otherwise the
brake pads will be forced shut.
To install the rear wheel
1. Install the wheel and the brake cal-
iper bracket by inserting the wheel
axle from the right-hand side.
6-28
NOTE:
G
Make sure that the retainer on the
swingarm is inserted into the slot in
the brake caliper bracket.
G
Make sure that there is enough
space between the brake pads be-
fore installing the wheel.
ECA11070
1. Retainer
2. Slot
2. Install the drive chain onto the rear
sprocket.
3. Install the washer and axle nut,
and then lower the rear wheel so
EAU41320
that it is on the ground.
4. Adjust the drive chain slack. (See
page 6-20.)
5. Tighten the axle nut to the speci-
fied torque.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
