Yamaha PW50(Z) Owner's Manual page 57

1. Exhaust manifold bolt
7. Remove the right-side rear shock
absorber mounting bolt and then
tilt the rear shock absorber upward
as shown.
1. Rear shock absorber mounting bolt
8. Remove the axle nut while apply-
ing the rear brake.
PERIODIC MAINTENANCE AND ADJUSTMENT
1
1. Axle nut
9. Remove the rear arm by removing
the nuts and washers.
1. Rear arm
1
2. Washer
3. Rear arm nut
10. Pull the wheel to the right to sepa-
rate it from the final gear case, and
1
1
2
3
7-21
then remove the wheel.
To install the rear wheel
1. Apply a light coating of lithi-
um-soap-based grease to the
splines of the final gear case and
wheel hub.
2. Install the wheel by inserting it into
the wheel hub.
3. Install the rear arm by installing the
washers and nuts.
4. Install the axle nut.
5. Install the right-side rear shock ab-
sorber by installing the mounting
bolt.
6. While applying the rear brake,
tighten the axle nut to the specified
torque.
7. Tighten the rear arm nuts and rear
shock absorber mounting bolt to
the specified torques.
Tightening torques:
Axle nut:
60 Nm (6.0 m·kgf, 43.4 ft·lbf)
Rear arm nut:
28.5 Nm (2.9 m·kgf, 20.6 ft·lbf)
Rear shock absorber mounting bolt:
22.5 Nm (2.3 m·kgf, 16.3 ft·lbf)
EAU41521
2
3
4
5
6
7
8
9