Yamaha YZ250(S)/LC Owner's Service Manual page 118

1 Ground lead
2 Ignition coil lead
3 Clamp
4 Wireharness
5 CDI magneto lead
6 YPVS breather hose
7 Radiator breather hose
8 Cable guide
9 "ENGINE STOP" button lead
0 Brake hose
A Pass the "ENGINE STOP" but-
ton lead on the inside of the
ignition coil lead and ground
lead.
CABLE ROUTING DIAGRAM
B Clamp the "ENGINE STOP" but-
ton lead, ground lead, ignition
coil lead, wireharness and CDI
magneto lead with the clamp
ends downward.
In so doing, clamp the "ENGINE
STOP" button lead at its con-
nector and do not allow the CDI
magneto lead to slacken.
Also make sure that the ignition
coil lead is not pulled.
C Pass the radiator breather hose
outside the engine bracket and
inside the down-tube.Pass the
radiator breather hose inside
the CDI magneto lead.
D Clamp the CDI magneto lead,
radiator breather hose and
YPVS breather hose. In so
doing, clamp the CDI magneto
lead at the rear of the down-tube
with the clamp ends outward.
2-14
SPEC
E Clamp the radiator breather
hose and CDI magneto lead at
the rear of the down-tube with
the clamp ends outward.
F Pass the radiator breather hose
and CDI magneto lead in front
of the radiator hose.
G Pass the radiator breather hose
between the frame and radiator.
H Align the top of the brake hose
neck with the brake hose holder
bottom.
I Pass the brake hose in front of
the axle boss,then fit it into the
hose groove so that the brake
hose does not contact the nut
(wheel axle).
J Fit the brake hose into the guide
on the protector.