Procedure 3 Connector Check And Replacement Check - Toshiba PORTEGE Z830 Satellite Z830 Maintenance Manual

Troubleshooting Procedures

2.5.3 Procedure 3 Connector Check and Replacement Check

USB FDD is connected to USB port on LAN/3G/USB 3.0 board or System board. The
connection of the cable and board may be defective. Otherwise, they may be faulty.
Disassemble the computer following the steps described in Chapter 4, Replacement
Procedures and perform the following checks.
USB FDD can be connected to the following 3 ports.
(USB port on LAN/3G/USB 3.0 board 1 port and System board 2 ports.)
Check 1 Make sure USB FDD is firmly connected to USB port. If the connection is loose,
connect firmly and repeat Procedure 2. If the problem still occurs, go to Check 2
.
2-34
PORTEGE Z830 Satellite Z830 Series Maintenance Manual (960-883) [CONFIDENTIAL]