17 CONTRACTURE FOOT ASSEMBLY
Replacing the Contracture Footplate Heel Loop
This procedure applies to the bilateral contracture
footplate only.
1.
Tilt the contracture footplate forward to gain access to the
mounting screws that secure the heel loop to the underside of the
contracture footplate. Refer to Adjusting the Angle of the Bilateral
Contracture Footplate on page 100.
2.
Remove the four mounting screws and washers that secure the
existing heel loop to the contracture footplate.
3.
Reverse STEPS 1-2 to install the new heel loop.
Solara 3G/Spree 3G Wheelchair
Mounting Screws
Washers
FIGURE 8
Replacing the Contracture Footplate Heel Loop
106
Washers
Contracture
Heel Loop
Part No 1154295
Footplate