Invacare Solara 3G User Manual page 62

10 ARMS
Adjusting Non-Locking Cantilever Arm Height
1. Remove the locknut and washer from the lower hex bolt securing
the cantilever arm to the back cane.
2. Slide the cantilever arm assembly out of the back cane.
3. Reposition the cantilever arm assembly to the desired mounting
hole.
4. Secure the cantilever arm to the wheelchair with a washer and
locknut.
Adjusting Non-Locking Cantilever Arm Angle
1. Loosen the mounting screw securing the cam to the cantilever arm.
2. Rotate the cam until the desired angle is achieved (Detail "A").
3. Tighten the mounting screw securing the cam to the cantilever arm.
Solara 3G/Spree 3G Wheelchair
Side View of Cam
Back
Cane
Cantilever
DETAIL "A" -
CAM POSITIONS
NOTE: All arm angles
are relative to the
back cane.
8° Arm Angle
FIGURE 15 Adjusting Non-Locking Cantilever Arm
62
Mounting Screw
Cam
Arm
4° Arm Angle
0° Arm Angle
Back Cane
Cam
12° Arm Angle
16° Arm Angle
Angle
Part No 1154295
Back Cane
Cantilever Arm