14 WHEELS/FORKS
5.
Adjust the wheel locks. Refer to Wheel Lock Adjustment on page 85.
Only 12-inch rear wheel is shown. All other wheels will install/remove in the same manner.
Permanent Axle
To remove rear wheels, reverse this procedure.
1.
Remove the permanent axles from the packaged container.
2.
Install permanent axle through lock washer and the rear wheel and axle plate.
3.
Securely tighten the wheel to the wheelchair frame with locknut.
Only 12-inch rear wheel is shown. All other wheels will install/remove in the same manner
4.
Repeat STEPS 2-3 for other rear wheel assembly.
5.
Adjust the wheel locks. Refer to Adjusting The Quick-Release Axle on page 83.
Solara 3G/Spree 3G Wheelchair
Rear Wheel
Locking Pins
Detent Pin
Quick-Release Axle
FIGURE 1 Installing/Removing Rear Wheels
Wheelchair Frame
Axle
Mounting
Plate
82
.
Part No 1154295