Installing Batteries Into Wheelchair - Invacare TDX SP User Manual

7 SETUP/MAINTENANCE

Installing Batteries into Wheelchair

For this procedure, refer to FIGURE 2 on page 85 and FIGURE 3 on page 87.

Positioning of the batteries into the battery tray is completed with battery tray positioned in wheelchair and partially pulled
out. Refer to FIGURE 2 for full view of wheelchair base. Illustrations in FIGURE 3 on page 87 are shown without the
wheelchair for clarification purposes only.
1. Position the battery with battery connector bracket in the rear of the battery tray in the orientation as shown. See Detail "A" of FIGURE 3 on
page 87 .
 Front of battery tray is designated by the battery stop. Rear of the battery tray is the opposite end.
Orientation of the battery is critical otherwise batteries will not connect to the controller or each other.
2. Position the remaining battery in the front of the battery tray in the orientation shown so that the wiring harnesses can be connected together.
See Detail "B" of FIGURE 3 on page 87.
3. Connect front battery to rear battery. See Detail "B" of FIGURE 3 on page 87.
4. Connect battery straps. See Detail "C" of FIGURE 3 on page 87.
5. Slide the battery tray into the wheelchair (FIGURE 2).
6. Install the battery door and rear shroud. Refer to Installing the Front Shroud/Battery Retention Bracket and Rear Shroud on page 88.
Invacare® TDX®SP, TDX SR
86
Part No 1143190