7 Seat and Back
WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely. Otherwise
injury or damage may occur.
7.1 Replacing Back Upholstery
1.
Remove the eight mounting screws and washers that secure the
existing back upholstery to the back canes.
2.
Remove existing back upholstery from the back canes.
3.
Securely tighten the new back upholstery to the back canes with the
mounting screws and washers.
7.2 Replacing Seat Upholstery
1.
Perform one of the following:
•
18 inch Deep Seats: Remove the ten mounting screws and
washers that secure the existing seat upholstery to the
crossbraces.
•
20 inch Deep Seats: Remove the twelve mounting screws and
washers that secure the existing seat upholstery to the
crossbraces.
2.
Remove the existing seat upholstery from the crossbraces.
3.
Ensure positioning of seat positioning strap (if used). Refer to
Installing the Seat Positioning Strap on page 61.
4.
Install new seat upholstery by reversing STEPS 1-2.
Part No. 1110558
Washers
Mounting
Screws
Washers
Mounting Screws
FIGURE 1 Replacing Back Upholstery/Replacing Seat Upholstery
43
Invacare® Tracer IV®Heavy Duty/Extra Wide Wheelchair
7 SEAT AND BACK
Back Upholstery
16-inch Seat
Depth
Wheelchair
Frame
Seat
Upholstery