Replacing Heel Loop - Invacare Tracer IV Heavy Duty User Manual

Calf Strap
5.5

Replacing Heel Loop


For this procedure, refer to FIGURE 6 on page 40.
1. Pull the cam lock lever up to unlocked position.
2. Perform one of the following as shown in Detail "A".
• Footplates with Spring Buttons: Push in the release buttons and remove the footplate assembly from the front rigging support.
• Bolt-In-Place Footplates:
i. Using a screw driver to hold the threaded rivet in position, remove the button head screw from the threaded rivet.
ii. Remove the threaded rivet and button head screw securing the footplate assembly to the front rigging support.
3. Remove the mounting screw, spacer and locknut that secure the heel loop to the footplate.
4. Remove existing heel loop from slide tube.
5. Install new heel loop onto slide tube.
6. Install the mounting screw, spacer and locknut to secure the heel loop to the footplate. Tighten until the spacer is secure.
7. Insert the lower footrest assembly into the upper footrest assembly to desired height.
Part No. 1110558
Calf Strap
Footrest
FIGURE 5 Installing H-Strap/Calf Strap
39
Invacare® Tracer IV®Heavy Duty/Extra Wide Wheelchair
5 FRONT RIGGINGS
H-Strap
Footrest
H-Strap