Jenn-Air 30" (76.2 CM) Installation Instructions Manual page 19

3. Turn the green Number .0430 LP gas oven broil burner orifice
hood counterclockwise to remove.
A. Number .0430 LP gas oven broil burner orifice hood
4. Install the Number 52 Natural gas oven broil burner orifice
hood, turning it clockwise 4 or 5 turns. Do not overtighten.
A. Number 52 Natural gas oven broil burner orifice hood
5. Place the oven broil burner on the oven broil burner orifice
hood. Insert the oven broil burner locator pin in the hole in the
oven back.
6. Position the oven broil burner against the roof of the oven
cavity and attach with screw.
A B
A. Oven broil burner orifice hood
B. Oven broil burner
To Convert Surface Burners
1. If they are installed, remove the burner grates.
2. Remove the burner caps.
3. On models with a dual burner, remove the LP choke from the
dual burner.
A
A
52
C
D
C. Oven broil burner locator pin
D. Oven broil burner locator hole
4. Using a Phillips screwdriver, remove the burner base.
A
B
A. Burner cap
B. Gas tube opening
5. Apply masking tape to the end of a
help hold the LP gas orifice spud in the nut driver while
changing it. Press nut driver down onto the LP gas orifice
spud and remove by turning it counterclockwise and lifting
out. Set the LP gas orifice spud aside.
A
A. Natural gas orifice spud
B. Dual burner
C. Single burner
Use the following chart for correct Natural gas orifice spud for
each burner. Refer to the gas information plate on the lower left
side of the front frame for proper sizing of Natural orifice spuds
for each burner location.
Natural Gas Orifice Spud Chart for Models JGS8850 and
JGS8860
Location Burner Rating
Right Front 16,000 BTU
Right Rear 5,000 BTU
Left Front 15,000 BTU
Left Rear 9,200 BTU
Natural Gas Orifice Spud Chart for Model JGS8750
Location Burner Rating
Right Front 16,000 BTU
Right Rear 9,200 BTU
Left Front 9,200 BTU
Left Rear 5,000 BTU
6. Replace the LP gas orifice spud with correct Natural gas
orifice spud. See the "Natural Gas Orifice Spud Chart."
7. Replace burner base and hand tighten the screws.
C
D
C. Burner base screws
D. Burner base
" (7 mm) nut driver to
B C
Color Number
Clear 190N
Green 107N
Center: Clear Center: 80N
Outer: Clear Outer: 165N
Clear 142N
Color Number
Clear 190L
Clear 142L
Clear 142L
Green 107L
19