Setup; Installing The Batteries; Volume; Led Indicator - Kogan KATMRBBQWLA User Manual

SETUP

INSTALLING THE BATTERIES

Follow these steps to install the batteries.
In the Monitor (Figures 3, 5and 7)
1. Lift the belt clip off the back of the monitor. Slide then lift up to remove the
battery compartment cover.
2. Place 2 x AA batteries in the compartment, in accordance with the polarity
symbols (+ and -).
3. Press 'reset' in the battery compartment using a pointed object, such as a paper clip
(Figure5) Note: Reset both the monitor and the thermometer sensor within 60
seconds to synchronize signal transmission.
4. Replace the cover and the belt clip.
In the Thermometer Sensor (Figure 4)
1. Slide the battery compartment cover open.
2. Insert 2 x AAA size batteries into the compartment, in accordance with the
polarity symbols. Press reset using a pointed object, such as a paper clip.
3. Replace the battery compartment cover.
Note: when
℃℉ (Figure 6)
/
To select Fahrenheit or Celsius, slide the ℃/℉switch.
Volume (Figure 6)
To adjust the monitor's volume, slide the Hi/Lo switch, located in the thermometer
battery compartment.
LED INDICATOR (Figure 2)
The red LED in the middle of the thermometer sensor flashes to indicate that it is on
and transmitting.
KATMRBBQWLA E-user manual
appears on the monitor, replace the batteries.
4