Replacing An Iop - HP NetServer AA 4000 Reference Manual

Replacing an IOP

Removing an IOP
Preparing a New IOP for Installation
Network Server Division
9. Attach the cables to the SSDL. Make sure to attach the correct
cables to the correct ports. Refer to the label step mentioned
previously.
10. Attach both SSDL power cords to the SSDL and their power
source.
11. Boot the systems.
12. On each SSDL, make sure that the status lights in column 1 and
2 are lit green.
13. If one of these status lights is red or not lit, correct the condition
and continue.
14. Using the Marathon Manager:
•
Make sure that the systems rejoin the Endurance 4000.
•
Make sure that any components affected by this procedure
are active or online.
•
Re-enable any faulted or disabled components.
To replace an IOP, complete the following procedures:
•
Removing an IOP
•
Preparing a New IOP for Installation
•
Installing the New IOP
To remove an IOP from the Endurance 4000 configuration:
1. Use the Marathon Manger to shut down the IOP.
2. Label and then detach the following cables from the IOP:
•
The powercord from the IOP.
•
The MIC cable by loosening the connector screws and
detaching the cables.
•
The Ethernet cable that connects the IOP to the public
Ethernet network.
•
The IL cable from the IOP.
•
The video cable, the keyboard, and the mouse.
3. If the IOP is rackmounted, remove it from the rack, and remove
the rackmount brackets.
1. After removing the IOP from the Endurance 4000 configuration,
prepare the replacement IOP for installation by completing the
following:
Ch 7: Bsic Troubleshooting
7-15