HP Integrity Superdome 2 16-socket Getting Started Manual page 4

HP Blade System Architecture
NIC 2(embedded)
NIC 3(embedded)
NIC 4(embedded)
Figure 3
Figure 3
1
2
3
5
7
9
11
2
Enclosure rear view
1
Enclosure fans
2
3 Interconnect module bay 1
4 Interconnect module bay 2
Interconnect module bay 3
5
Interconnect module bay 4
6
Consider these prerequisites before you install the switch module:
Fill any unoccupied interconnect bays or any unoccupied power module bays in the blade
•
enclosure with blanks.
Identify the bays in which you will insert the switch modules. Plan to install the first switch module
•
in bay 1, the second in bay 2, and so on up to bay 8, if possible. The bay in which you choose to
install each switch module depends on whether mezzanine or Ethernet cards are installed in the
blade enclosure and how they are configured. See the blade enclosure documentation information
about installing and configuring the mezzanine or Ethernet cards.
See the HP c-Class or HP Integrity Superdome 2 documentation for information on the port mapping
•
between blade enclosures and the switch modules.
Cisco Nexus B22 Fabric Extender for HP Getting Started Guide
4
2
1
2
shows the rear view of the enclosure, in which you install the switch module.
Rear View of the Enclosure
orange interconnect label
orange interconnect label
orange interconnect label
Interconnect module bay 5
7
Interconnect module bay 6
8
9 Interconnect module bay 7
10 Interconnect module bay 8
11 Onboard Administrator module
4
6
8
10