Verifying The Configuration - HP Integrity Superdome 2 16-socket Getting Started Manual

Part Revision
Mfg Deviation
H/W Version
Mfg Bits
Engineer Use
snmpOID
Power Consump
RMA Code
CLEI Code
VID
Supervisor Module specific block:
Block Signature : 0x0
Block Version
Block Length
Block Checksum
Feature Bits
HW Changes Bits : 0x0
Card Index
MAC Addresses
Number of MACs
Number of EPLD
Port Type-Num
Sensor #1
Sensor #2
Sensor #3
Sensor #4
Sensor #5
Sensor #6
Sensor #7
Sensor #8
Max Connector Power: 0
Cooling Requirement: 0
Ambient Temperature: 0
switch(config-fex)#
switch(config-fex)#
switch(config-fex)#
switch(config-fex)#
switch(config-fex)#
switch(config-fex)#

Verifying the Configuration

The Onboard Administrator (OA) is the management module used to support and manage the HP
BladeSystem c-Class enclosure or the HP Integrity Superdome 2 and all the devices used in the
enclosure. Once the switch is installed in the interconnect bay, the OA verifies that the switch type
matches the mezzanine cards present on the server blades. If there is no mismatch, the OA powers on the
switch. If the switch does not power on, check the enclosure and switch status using the OA web
interface. For more information and troubleshooting tips, see the HP BladeSystem Onboard
Administrator User Guide or the or the HP Integrity Superdome 2 Onboard Administrator User Guide.
To verify the configuration,
1.
:
:
: 0.0
: 0
: 0
: 0.0.0.0.0.0.0.0
: 0
: 0-0-0-0
:
: V00
: 0
: 0
: 0x0
: 0x0
: 0
: 00-00-00-00-00-00
: 0
: 0
: 0-0
: 0,0
: 0,0
: 0,0
: 0,0
: 0,0
: 0,0
: 0,0
: 0,0
Locate the LEDs. See Figure 6.
Cisco Nexus B22 Fabric Extender for HP Getting Started Guide
Verifying the Configuration
19