IOGear GCS1722 User Manual page 28

Upgrade Succeeded
As the Upgrade proceeds status messages will appear
in the Status Messages panel, and the progress toward
completion is shown on the Progress bar.
After the upgrade has completed, a screen appears to
inform you that the procedure was successful:
Click Finish to close the Firmware Upgrade Utility.
After a successful completion, the GCS1722 / GCS1724
exits Firmware Upgrade Mode, and resets itself.
Upgrade Failed
If the Upgrade Succeeded screen doesn't appear, it means
that the upgrade failed to complete successfully, in which
case you should do the following:
1. Press and hold the Port 1 selection switch. While
you are holding the switch, connect the GCS1722 /
GCS1724 to the computer using the USB cable of
the custom cable set (see diagram, page 25) to enter
Firmware Upgrade Mode. The front panel LEDs flash to
indicate that Firmware Upgrade Mode is in effect.
2. Run the upgrade again. See Starting the Upgrade,
page 26.
- 28 -