Hp Sn6000C Fabric Switch; Cisco Mds 8Gb Fabric Switch For Hp Bladesystem C-Class - HP Cisco MDS 8/12c Release Note

5. Enter the following command to enable the VSAN(s) that contain the Continuous Access
EVA and/or DRM fabric to src-dst-id loadbalancing:
switch(config-vsan-db)# vsan <1-4094> loadbalancing src-dst-id
switch(config-vsan-db)# exit
switch(config)# exit
6. Verify that src-dst-id is enabled for the desired VSAN by entering the following
command:
switch# show vsan <1-4094>
In the following example, VSAN 1 loadbalancing is set to src-id/dst-id
switch# show vsan 1
vsan 1 information
name: vsan1
interoperability mode: default
loadbalancing: src-id/dst-id
operational state: up
7. Type the following to copy the running configuration into the startup configuration:
switch# copy running-config startup-config
Refer to the Fabric Configuration Guide, Cisco DCNM for SAN, Cisco DCNM for SAN, Release
5.x to set
LoadBalancing value to srcdst
Note: The running configuration overwrites the startup configuration.

HP SN6000C FABRIC SWITCH

The HP SN6000C Fabric Switches (MDS 9148) have fixed configurations with 16 and 32 full
rate 8-Gbps fibre channel ports. The switch can be upgraded up to 48-ports in 8 port increments
with an on demand port activation license.
CISCO MDS 8Gb FABRIC SWITCH FOR HP
BLADESYSTEM c-CLASS
The Cisco MDS 8Gb 12-port fabric switch and the MDS Cisco 8Gb 24-port fabric switch for HP
BladeSystem c-Class have fixed configurations with 8-internal/4-external or 16-internal/8-
external full rate 8-Gbps fibre channel ports. The 12-port switch can be upgraded to the 24-port
switch with an on demand port activation license.
Note: For the latest supported mezzanine software, refer to the HP Single Point of Connectivity
Knowledge (SPOCK) website at http://www.hp.com/storage/spock. You must sign up for an HP Passport
to be granted access. For the latest supported c-Class Onboard Administrator firmware, refer to hp.com.
Note: It is recommended to set the mezzanine adapter to the desired port speed instead of using the default
speed of auto.
23 MDS 9000 Series Multilayer Director & Multilayer Fabric Switches Release Notes
state: active
using Device Manager/DCNM.