Enclosure Configuration; Locating Configuration Instructions; Running The Insight Display Wizard; Running The Onboard Administrator First Time Setup Wizard - HP Cisco Catalyst Blade Switch 3020 Overview

Enclosure configuration

Locating configuration instructions

For specific instructions on configuring your enclosure, see the HP BladeSystem Onboard Administrator User
Guide on the HP website (http://www.hp.com/go/oa).

Running the Insight Display wizard

When the enclosure is powered up for the first time, the HP BladeSystem Insight Display launches an
installation wizard to guide the rack technician through the initial configuration process.
Be sure to have the Installation Checklist available to record important information, such as the Onboard
Administrator IP address, gathered while running the installation wizard. By default, the Onboard
Administrator obtains an IP address using DHCP. Read the Insight Display and write the IP address for the
active and standby Onboard Administrator on the checklist. This IP address is needed for remote connection
and subsequent setup with a browser. If DHCP is not used, a static IP address can be configured on the Insight
Display Settings screen. For specific instructions, see the HP BladeSystem Onboard Administrator User Guide
on the HP website (http://www.hp.com/go/oa).
The Insight Display verifies that no installation or configuration errors exist and indicates configuration check
progress. If configuration errors are indicated, then follow the on-screen instructions to correct the problem.
When the screen display stays green, no configuration errors or device failures exist and hardware
installation is complete.
Running the Onboard Administrator First Time Setup
wizard
After all hardware is installed and the hardware configuration has been verified in the Insight Display, use
one of the following methods to complete the enclosure configuration setup:
•
Use the Insight Display to determine the address received by DHCP, and then use the Onboard
Administrator First Time Setup Wizard to complete the installation and configuration at the assigned
address.
•
If no DHCP server is present on the customer management network, do one of the following:
Use the Insight Display to set the address, and then use the Onboard Administrator First Time Setup
o
Wizard to complete the installation and configuration at the assigned address.
Use the Onboard Administrator First Time Setup Wizard or the CLI to configure EBIPA and assign IP
o
addresses for iLO and interconnect management ports. This method simplifies the required setup for
interconnect management network settings.
•
Use the Insight Display to set the IP address and complete the Onboard Administrator First Time Setup
Wizard from the Insight Display. This method enables configuration without the use of an external
browser.
Enclosure configuration 10