Documentation Updates - HP Cisco Catalyst Blade Switch 3020 Release Note

•
•

Documentation Updates

The "Supported MIBs" appendix is no longer in the software configuration guide. To locate and
Note
download MIBs for a specific Cisco product and release, use the Cisco MIB Locator:
http://cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml.
•
•
•
Updates to the Software Configuration Guide
Correction to the "Unsupported Commands" Chapter
The "Miscellaneous" section of the "Unsupported Commands" chapter should include the logging
discriminator global configuration command.
OL-24325-01
The workaround is to disable IPv6 MLD snooping on the switch.
CSCtl80678
The port manager callback might cause more than 90% CPU usage for up to 20 minutes under these
conditions:
Link comes up simultaneously on multiple dot1q trunk ports.
–
VLAN Trunking Protocol (VTP) pruning is enabled.
–
The workaround is to disable VTP pruning.
CSCto62631
A switch running Cisco IOS Release 12.2(58)SE might reload if:
SSH version 2 is configured on the switch, and
–
a customized login banner was configured by using the banner login message global
–
configuration command
Use one of these workarounds:
Disable the login banner by entering the no login banner command.
–
Disable SSH on the switch.
–
Downgrade to a software version prior to Cisco IOS Release 12.2(58)SE.
–
"Updates to the Software Configuration Guide" section on page 17
"Updates to the System Message Guide" section on page 18
"Updates to the Getting Started Guide" section on page 21
Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(58)SE and Later
Documentation Updates
17