Documentation Updates - HP Cisco Catalyst Blade Switch 3020 Release Note

Documentation Updates

•
•
•
•
•
•
Documentation Updates
This section provides updates to the product documentation:
•
•
Update to the Software Configuration Guide
This text was updated in the "Using IEEE 802.1x Authentication with Guest VLAN section of the
software configuration guide:
If the switch is trying to authorize an IEEE 802.1x-capable voice device and the AAA server is
unavailable, the authorization attempt fails, but the detection of the EAPOL packet is saved in the
EAPOL history. When the AAA server becomes available, the switch authorizes the voice device.
However, the switch no longer allows other devices access to the guest VLAN. To prevent this situation,
use one of these command sequences:
•
•
Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(44)SE and Later
24
CSCsk25175
When the switch has VTP pruning and an RSPAN session configured, the RSPAN VLAN traffic is
now correctly pruned as set up by the VTP pruning configuration.
CSCsk38083
When UDLD is enabled on a Layer 2 interface, and the native VLAN for the port is not configured
as a VLAN on the switch, UDLD no longer puts the port into an error-disabled state.
CSCsk67520
If you enter the hostname global configuration command followed by a hostname that contains
illegal characters, for example, one that appears to be an IP address, the switch now displays a
warning message, but the specified hostname is configured.
CSCsi85257
A Cisco IP Phone now works correctly when it is connected to a port that is configured with CDP
bypass and multidomain authentication (MDA).
CSCsk62010
A switch no longer fails when you enter the show interfaces vlan vlan-id switchport privileged
EXEC command.
CSCsl33304
Web authentication no longer stops working when IEEE 802.1X re-authentication is enabled and the
re-authentication timer expires.
"Update to the Software Configuration Guide" section on page 24
"System Messages Guide" section on page 25
Enter the dot1x guest-vlan supplicant global configuration command to allow access to the guest
VLAN.
Enter the shutdown interface configuration command followed by the no shutdown interface
configuration command to restart the port.
464831-005