Brocade Communications Systems Brocade 8/12c Installation Manual page 10

Management server and client ports
TABLE 3
Professional ports (Continued)
Port Number Ports
24610 connector.bind.port – port 10
1 Port is not configurable (either in the switch or the Management server).
2 Every FTP session requires an additional port which is randomly picked. If the firewall is enabled then FTP operation (used for firmware
download, technical support, firmware import (from client-server) and so on.) will fail.
3 Ports configurable in the switch and the Management server. Port must be the same for all switches managed by the Management
server.
4 Ports used to launch the Web Tools application for Fabric OS switches from the Management client. This is applicable only when the
Fabric OS version is earlier than 6.1.1.
5 Port 80 is the default web server port number. If you set the web server port number to a port other than the default, you must open that
port in the firewall.
6 The Syslog listening port is configurable in the Management server. The switch always sends syslog messages to port 514. If you have
any other syslog daemon on the Management server machine already listening to 514, then the Management Server can be configured
to listen to a different port. You must manually configure relay in existing syslogd to forward the syslog messages to the Management
Server listening on the configured port.
7 The Management server tries to find a contiguous block of 13 ports from the starting port configured (for example, 24600); if any port in
this range is not available for the Management application, then you must provide a new starting port. Note that Port 1 to Port 12 in
"Ports" column of the table above are not separately configurable and those ports vary based on the starting port number configuration
(specified as Port 0 in the above table). The port numbers mentioned in the table above are the default ports (for example, when 24600
is selected as the starting port number).
Table 4 lists the ports that need to be opened up in the firewall for Trial and Licensed Version.
TABLE 4
Trial and Licensed Version ports
Port Number Ports
1
20 FTP Port (Control)
1, 2
21 FTP Port (Data)
1
22 SSH or Secure Telnet
1
23 Telnet
25 SMTP Server port
49 TACACS+ Authentication port
80 jboss.web.http.port
3, 4
80 Switch http
1
161 SNMP Port
3
162 snmp.trap.port
10 of 47
Transport Description
TCP Port to listen for requests on
Transport Description
TCP FTP Control port for internal
FTP server
TCP FTP Data port for internal
FTP server
TCP Sectelnet port from server to
switch/client to switch
TCP Telnet port from server/client
to switch
TCP SMTP Server port for E-mail
communication
TCP TACACS+ server port for
authentication if TACACS+ is
chosen as an external
authentication
TCP Non-SSL HTTP/1.1 connector
port
TCP Switch non-SSL http port for
http and CAL communication
UDP Default SNMP port
UDP Default SNMP trap port
Communication Path Open in Firewall
Server
Communication Path Open in Firewall
Client–Server
Switch–Server
Client–Server
Switch–Server
Server–Switch
Client–Switch
Server–Switch
Client–Switch
Server–SMTP
Server
Server–TACACS+
Server
Client–Server
Server–Switch
Client–Switch
Server–Switch
Switch–Server
Brocade Network Advisor Installation Guide
53-1002320-01
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes