Configuring Mac Address Learning For An S-Channel; Configuring A Vsi; Creating A Vsi - HP 6125XLG Configuration Manual

To configure RR mode for an S-channel:
Step
1. Enter system view.
2. Enter S-channel interface
view.
3. Enable RR mode for the
S-channel.

Configuring MAC address learning for an S-channel

You can manually disable the MAC address learning function for an S-channel by performing this task.
To disable MAC address learning for an S-channel:
Step
1. Enter system view.
2. Enter S-channel interface
view.
3. Disable MAC address
learning for the S-channel.

Configuring a VSI

Creating a VSI

A VSI is created on an S-channel interface through this task.
VSIs are typically created by a VSI manager. You can also create a VSI or modify its Pre-Associate and
Associate properties.
A VSI is a subinterface of an S-channel interface on an EVB bridge. Removing an S-channel also removes
all its VSIs.
Command
system-view
interface s-channel
interface-number:channel-id
evb reflective-relay
Command
system-view
interface s-channel
interface-number:channel-id
evb mac-learning forbidden
7
Remarks
N/A
N/A
By default, the RR mode is disabled
for an S-channel.
Remarks
N/A
N/A
By default, the MAC address
learning function is enabled for an
S-channel.
IMPORTANT:
•
For an S-channel with RR mode
disabled, do not disable its
MAC address learning
function. Otherwise, the bridge
might fail to forward traffic for
VMs on the EVB station.
•
After you disable the MAC
address learning function for
an S-channel, the bridge will
discard packets with an
unknown source MAC address.