Activating A Vsi; Displaying And Maintaining Evb; Evb Configuration Example - HP 6125XLG Configuration Manual

Activating a VSI

Configurations such as traffic policing for a VSI (see ACL and QoS Configuration Guide) take effect only
after the VSI is activated. When a VSI is not activated, do not make any configuration except for VSI filter
configuration for the VSI.
To activate a VSI, you must first configure a VSI filter. To remove a VSI filter for a VSI, you must first
deactivate the VSI.
To activate a VSI:
Step
1. Enter system view.
2. Enter VSI view.
3. Activate the VSI.
4. (Optional.) Configure a
description for the VSI.

Displaying and maintaining EVB

Execute display commands in any view and the reset command in user view.
Task
Display CDCP negotiation
information.
Display S-channel EVB TLV
negotiation information.
Display S-channel information.
Display EVB summary.
Display VSI information.
Display information about an
S-channel interface or a VSI.
Clear statistics for an S-channel
interface or a VSI.

EVB configuration example

Network requirements
As shown in
four EVB bridges, and four EVB stations. They communicate within VLAN 100.
Create VM 1 with a MAC address of 0050-5684-21C7 on EVB station 1, and set VM1 as the FTP server
with a CIR of 2048 kbps and a PIR of 4096 kbps. Only the R&D center is allowed to access the network.
Command
system-view
interface s-channel
interface-number:channel-id.vsi-lo
cal-id
evb vsi active
description text
Figure 3, the Layer 2 network of a data center comprises two switches that form an IRF fabric,
Command
display evb cdcp [ interface interface-type interface-number ]
display evb evb-tlv [ interface interface-type interface-number ]
display evb s-channel [ interface interface-type interface-number ]
display evb summary
display evb vsi [ verbose ] [ interface interface-type interface-number ]
display interface [ s-channel [ interface-number:channel-id |
interface-number:channel-id.vsi-local-id ] ] [ brief [ description ] ]
reset counters interface [ s-channel [ interface-number:channel-id |
interface-number:channel-id.vsi-local-id ] ]
9
Remarks
N/A
N/A
By default, no VSI is activated.
The default description information is
"interface name Interface."