HP 6125XLG Configuration Manual page 47

Blade switch irf configuration guide

Hide thumbs Also See for 6125XLG:

Table of Contents

Figure 16 Network diagram

Configuration procedure

Configure Device A:

# Shut down the physical ports used for IRF connection. This example uses the SFP+ port group that

contains Ten-GigabitEthernet 1/1/7, Ten-GigabitEthernet 1/1/8, Ten-GigabitEthernet 1/1/11,

and Ten-GigabitEthernet 1/1/12 for IRF connection.

<Sysname> system-view

[Sysname] interface range name irf interface ten-gigabitethernet 1/1/7

ten-gigabitethernet 1/1/8 ten-gigabitethernet 1/1/11 ten-gigabitethernet 1/1/12

[Sysname-if-range-irf] shutdown

[Sysname-if-range-irf] quit

# Bind Ten-GigabitEthernet 1/1/7 and Ten-GigabitEthernet 1/1/8 to IRF-port 1/1.

[Sysname] irf-port 1/1

[Sysname-irf-port1/1] port group interface ten-gigabitethernet 1/1/7

[Sysname-irf-port1/1] port group interface ten-gigabitethernet 1/1/8

[Sysname-irf-port1/1] quit

# Bind Ten-GigabitEthernet 1/1/11 and Ten-GigabitEthernet 1/1/12 to IRF-port 1/2.

[Sysname] irf-port 1/2

[Sysname-irf-port1/2] port group interface ten-gigabitethernet 1/1/11

[Sysname-irf-port1/2] port group interface ten-gigabitethernet 1/1/12

[Sysname-irf-port1/2] quit

# Bring up the SFP+ ports and save the configuration.

[Sysname] interface range name irf

[Sysname-if-range-irf] undo shutdown

Table of Contents