HP 6125XLG Configuration Manual page 40

[Sysname] save
# Activate the IRF port configuration.
[Sysname] irf-port-configuration active
Device C reboots to join the IRF fabric.
4. Configure Device D:
# Change the member ID of Device D to 4, and reboot the device to validate the change.
<Sysname> system-view
[Sysname] irf member 1 renumber 4
Renumbering the member ID may result in configuration change or loss. Continue? [Y/N]:y
[Sysname] quit
<Sysname> reboot
# Connect Device D to Device B and Device C as shown in
example uses the SFP+ port group that contains Ten-GigabitEthernet 4/1/7, Ten-GigabitEthernet
4/1/8, Ten-GigabitEthernet 4/1/11, and Ten-GigabitEthernet 4/1/12 for IRF connection.
# Shut down the physical ports.
<Sysname> system-view
[Sysname] interface range name irf interface ten-gigabitethernet 4/1/7
ten-gigabitethernet 4/1/8 ten-gigabitethernet 4/1/11 ten-gigabitethernet 4/1/12
[Sysname-if-range-irf] shutdown
[Sysname-if-range-irf] quit
# Bind Ten-GigabitEthernet 4/1/7 and Ten-GigabitEthernet 4/1/8 to IRF-port 4/1.
[Sysname] irf-port 4/1
[Sysname-irf-port4/1] port group interface ten-gigabitethernet 4/1/7
[Sysname-irf-port4/1] port group interface ten-gigabitethernet 4/1/8
[Sysname-irf-port4/1] quit
# Bind Ten-GigabitEthernet 4/1/11 and Ten-GigabitEthernet 4/1/12 to IRF-port 4/2.
[Sysname] irf-port 4/2
[Sysname-irf-port4/2] port group interface ten-gigabitethernet 4/1/11
[Sysname-irf-port4/2] port group interface ten-gigabitethernet 4/1/12
[Sysname-irf-port4/2] quit
# Bring up the SFP+ ports and save the configuration.
[Sysname] interface range name irf
[Sysname-if-range-irf] undo shutdown
[Sysname-if-range-irf] quit
[Sysname] save
# Activate the IRF port configuration.
[Sysname] irf-port-configuration active
Device D reboots to join the IRF fabric. A four-chassis IRF fabric is formed.
5. Configure LACP MAD on the IRF fabric:
# Set the domain ID of the IRF fabric to 1.
<Sysname> system-view
[Sysname] irf domain 1
# Create a dynamic aggregate interface and enable LACP MAD.
[Sysname] interface bridge-aggregation 2
[Sysname-Bridge-Aggregation2] link-aggregation mode dynamic
[Sysname-Bridge-Aggregation2] mad enable
Figure
36
14, and log in to Device D. This