HP 6125XLG Configuration Manual page 44

[Sysname-if-range-irf] quit
[Sysname] save
# Activate the IRF port configuration.
[Sysname] irf-port-configuration active
The two devices perform master election, and the one that has lost the election reboots to form an
IRF fabric with the master.
3. Configure Device C:
# Change the member ID of Device C to 3, and reboot the device to validate the change.
<Sysname> system-view
[Sysname] irf member 1 renumber 3
Renumbering the member ID may result in configuration change or loss. Continue? [Y/N]:y
[Sysname] quit
<Sysname> reboot
# Connect Device C to Device A as shown in
the SFP+ port group that contains Ten-GigabitEthernet 3/1/7, Ten-GigabitEthernet 3/1/8,
Ten-GigabitEthernet 3/1/11, and Ten-GigabitEthernet 3/1/12 for IRF connection.
# Shut down the physical ports.
<Sysname> system-view
[Sysname] interface range name irf interface ten-gigabitethernet 3/1/7
ten-gigabitethernet 3/1/8 ten-gigabitethernet 3/1/11 ten-gigabitethernet 3/1/12
[Sysname-if-range-irf] shutdown
[Sysname-if-range-irf] quit
# Bind Ten-GigabitEthernet 3/1/7 and Ten-GigabitEthernet 3/1/8 to IRF-port 3/1.
[Sysname] irf-port 3/1
[Sysname-irf-port3/1] port group interface ten-gigabitethernet 3/1/7
[Sysname-irf-port3/1] port group interface ten-gigabitethernet 3/1/8
[Sysname-irf-port3/1] quit
# Bind Ten-GigabitEthernet 3/1/11 and Ten-GigabitEthernet 3/1/12 to IRF-port 3/2.
[Sysname] irf-port 3/2
[Sysname-irf-port3/2] port group interface ten-gigabitethernet 3/1/11
[Sysname-irf-port3/2] port group interface ten-gigabitethernet 3/1/12
[Sysname-irf-port3/2] quit
# Bring up the SFP+ ports and save the configuration.
[Sysname] interface range name irf
[Sysname-if-range-irf] undo shutdown
[Sysname-if-range-irf] quit
[Sysname] save
# Activate the IRF port configuration.
[Sysname] irf-port-configuration active
Device C reboots to join the IRF fabric.
4. Configure Device D:
# Change the member ID of Device D to 4, and reboot the device to validate the change.
<Sysname> system-view
[Sysname] irf member 1 renumber 4
Renumbering the member ID may result in configuration change or loss. Continue? [Y/N]:y
[Sysname] quit
Figure 15, and log in to Device C. This example uses
40