HP ProCurve Switch 6120G/XG Manual page 76

factory-default configuration. This can disrupt network operation and make
it necessary to temporarily disconnect the switch from the network to prevent
unauthorized access and other problems while it is being reconfigured. Also,
with factory-reset enabled, unauthorized users can use the Reset+Clear button
combination to reset the switch to factory-default configuration and gain
management access to the switch.
Syntax: [no] front-panel-security password-recovery
Enables or (using the "no" form of the command) disables the
ability to recover a lost password.
When this feature is enabled, the switch allows management
access through the password recovery process described below.
This provides a method for recovering from a lost manager
username (if configured) and password. When this feature is
disabled, the password recovery process is disabled and the
only way to regain management access to the switch is to use
the Reset+Clear button combination (page 2-25) to restore the
switch to its factory default configuration.
Note: To disable password-recovery:
– You must have physical access to the front panel of the switch.
– The factory-reset parameter must be enabled (the default).
(Default: Enabled.)
Steps for Disabling Password-Recovery.
1. Set the CLI to the global interface context.
Use show front-panel-security to determine whether the factory-reset
2.
parameter is enabled. If it is disabled, use the front-panel-security factory-
reset command to enable it.
3. Press and release the Clear button on the front panel of the switch.
4. Within 60-seconds of pressing the Clear button, enter the following com-
mand:
no front-panel-security password-recovery
5. Do one of the following after the "CAUTION" message appears:
• If you want to complete the command, press
• If you want to abort the command, press
Figure 2-14 shows an example of disabling the password-recovery parameter.
Configuring Username and Password Security
(for "Yes").
[Y]
[N] (for "No")
Password Recovery
2-33