Configuring Ip Authorized Managers For The Switch - HP ProCurve Switch 6120G/XG Manual

Figure 12-3.Example of the Show IP Authorized-Manager Display
The above example shows an Authorized IP Manager List that allows stations
to access the switch as shown below:
IP Mask Authorized Station IP Address:
255.255.255.252
255.255.255.254
255.255.255.255
255.255.255.0

Configuring IP Authorized Managers for the Switch

Syntax: ip authorized-managers <ip address>
Configures one or more authorized IP addresses.
[<ip-mask-bits>]
Configures the IP mask for < ip address >
[access <operator | manager>]
Configures the privilege level for < ip address>. Applies only
to access through Telnet, SNMPv1, and SNMPv2c. Refer to
the Note on page 12-3.
To Authorize Manager Access. This command authorizes manager-level
access for any station with an IP address of 10.28.227.0 through 10.28.227.255:
ProCurve(conf
255.255.255.0 access manager
Similarly, the next command authorizes manager-level access for any station
having an IP address of 10.28.227.101 through 103:
ProCurve(config)# ip authorized-managers 10.28.227.101
255.255.255.252 access manager
10.28.227.100 through 103
10.28.227.104 through 105
10.28.227.125
10.28.227.0 through 255
)# ip authorized-managers 10.28.227.101
ig
Using Authorized IP Managers
Defining Authorized Management Stations
Access Mode:
Manager
Manager
Manager
Operator
12-7