Sound Adjustment - Toshiba 23PU200 series Owner's Manual

to reproduce a smooth motion and picture quality,
select the On mode.
Eff ective signal and setup conditions:
• When the Video input mode is selected.
• When the input signal format is 480i, 576i or 1080i
signals.
• Use the menus: PICTURE and Picture Settings
• Use the item: Cinema Mode
Note:
When a DVD movie with subtitle is playing back, this
mode may not work correctly.
Adjusting the Colour Temperature
Colour Temperature increases the warmth or
coolness of the picture by setting the red, green or
blue tint.
• Use the menus: PICTURE and Picture Settings
• Use the items: Colour Temperature, Red Level,
Green Level and Blue Level
• Use the modes: Cool, Natural and Warm
Resetting the Picture Settings
• Use the menus: PICTURE and Picture Settings
• Use the item: Reset (select Yes and press Q)
Activating the Noise Reduction (NR)
If the receiving signal of MPEG is a mosquito
(grained) noise depending on the compression and
conversion, the picture is weak and the picture is
blurry, the picture may be improved when using this
function.
• Use the menus: PICTURE and Noise Reduction
• Use the items: Auto Clean, MPEG NR and DNR
• Use the modes: Low, Middle, High and Off
Adjusting the Colour Management
You can adjust the picture colour quality by
selecting from 6 base colour adjustments : Red,
Green, Blue, Yellow, Magenta or Cyan.
• Use the menus: PICTURE, 3D Colour
Management (On) and Base Colour Adjustment
• Use the items: Hue, Saturation and Brightness
Resetting the Base Colour Adjustment
• Use the menus: PICTURE, 3D Colour
Management and Base Colour Adjustment
• Use the item: Reset
Using the Active Backlight Control
In order to improve screen visibility, the Active
Backlight Control sets the screen brightness
automatically during dark scenes.
• Use the menu: PICTURE
• Use the item: Active Backlight Control

Sound adjustment

Setting the MTS (Multi-channel TV Sound)
Auto mode
The MTS Auto mode automatically recognize
stereo/bilingual programmes depending on the
broadcast signal.
Mono mode
If you experience noise or poor reception of any
stereo/bilingual programme, set the MTS mode to
Mono.
Noise will be reduced and reception may improve.
• Use the menu: SOUND
• Use the item: MTS
Note:
If you experience noise with a particular programme
on whose channel reception is usually good, try setting
MTS mode to Auto, then press g to switch to
e Mono (monaural).
Selecting the Dual 1 or Dual 2 mode
You can hear only Dual 1 or Dual 2 sound selected,
whenever bilingual programmes are received.
• Use the menu: SOUND
• Use the item: Dual
Notes:
• When the MTS setting is in Mono mode, the Dual
menu is not selectable.
• The Dual menu setting status remains even if the TV
is turned off .
Selecting the stereo programmes
When a stereo programme is received, d Stereo
appears and press g.
• Use the modes: Stereo and Mono
Selecting the bilingual programmes
When a bilingual programme is received, j Dual
appears and press g.
Display
Sub I sound
j Dual 1
Sub II sound
J Dual 2
e Mono
Main sound
Note:
These settings are not stored in the TV memory.
– 15 –
Sound to be heard
German stereo/
NICAM
bilingual broadcast
Main sound
Sub sound
—