Grizzly G2790 Owner's Manual page 21

2.
place the slide table on a flat surface and
remove the three hex bolts and flat washers,
as shown in Figure 13.
slide table
Figure 13. slide table dismantled.
3.
remove the pivot support from the machine,
then secure it to the back of the slide table
with the three hex nuts and flat washers
removed in Step 2, as shown in Figure 14.
pivot support
Figure 14. pivot support attached to the slide
table.
g2790 universal Knife grinder
4.
re-attach the pivot support to the grinder
table so that the flat surface of the slide table
is facing the wheel, as shown in Figure 15.
hex Bolts
& Flat
Washers
assembly properly attached to the grinder.
5. lay the slide bar on a flat, stable surface,
remove the five lock screws, then remove the
knife clamp, as shown in Figure 16.
cutting tools are dangerously sharp, espe-
cially after sharpening. Use extreme caution
when handling these tools to reduce the risk
of personal injury.
Figure 15. pivot support and slide table
lock screws
slide Bar
Figure 16. slide bar dismantled.
Knife
Clamp
-19-