Attaching The Printer Cable; Power Up - Hitachi SCI Getting Started Manual

Attaching the Printer Cable

1. Plug the printer cable from the scanner into the connector located at
the back of the printer, as indicated below.
Printer Cable Connector

Power Up

1. Plug the power cord into the wall outlet.
To turn the power on, press the switch on the front of the scanner. A green
LED will light on the front of the scanner and the touch panel will display
a screen indicating the diagnostics are being run. When the diagnostics are
complete (about 2 minutes), the touch panel will display the Job Status
Screen.
If the LED does not light, or the diagnostics fail, call technical support.
1-8 Unpacking and Setup
Printer Interface
Scanner Indicator LED
Power
Switch