Haier DW12-PFE8 series Operation Manual page 24

Use of "3 in 1"/ Combi-Detergent Tablets
General Advice
1. Before using these products you should first check that the water hard-ness in
your supply is compatible with the use of these products as per the detergent
manufacturers instructions (on the product packaging).
2. These products should be strictly used according to the detergent manufacturers
instructions.
3. If you encounter problems when using "3 in1" products for the first time then
please contact the detergent manufacturers care line (the telephone number is
given on the product packaging).
Special Advice
When using combination products, the rinse-aid and salt lights are no longer useful.
It may be helpful to select the lowest possible setting for water hardness.
To select "Combi-Detergent tablets" function:
1. Close the door. Select the programme and then press the option button "D" until
the "Combi-Detergent tablets indicator"
2. Press the Start/Pause button "L", then the dishwasher will start immediately, and
the programme indicator and the "Combi-Detergent tablets indicator"
To cancel "Combi-Detergent tablets" function:
Follow the "Cancelling or modifying a cycle while underway" instructions.
If you decide to switch to the use of a standard detergent system we advise that
you:
1. Refill both the salt and rinse aid compartments.
2. Switch the water hardness setting to the highest possible position and run for
three normal cycles without a load.
3. Readjust the water hardness setting again according to the conditions for your
region (For more information please refer to your instruction manual).
23
55 o /65 o 70 o 55 o 50 o
D G
lights.
45 o 40 o cold
L
EN
blinks.