Appliance Self-Test - Siemens KG39EAI40G Instructions For Use Manual

Fault
Freezer compartment
temperature display
flashes. Fig. 2/4
Warning signal sounds
The Alarm button is lit.
Fig. 2/5
The freezer
compartment is too
warm!
The frozen food
is at risk of thawing!
Freezer compartment
temperature display
flashes. Fig. 2/4
Appliance is not
cooling, temperature
display and light
are lit.

Appliance self-test

Your appliance features an automatic
self-test program which shows you
sources of faults which may be repaired
by customer service only.
Starting the appliance self-test
1. Switch off the appliance and wait
5 minutes.
2. Switch on appliance and hold down
the super button, Fig. 2/2, for 3–
5 seconds within the first 10 seconds
until an acoustic signal sounds.
The self-test programme starts.
Possible cause
Appliance is open.
Ventilation openings
have been covered.
Too much food was
placed in the freezer
compartment at once.
A fault caused
the freezer
compartment
to become too warm
in the past.
Showroom mode is
switched on.
Remedial action
To switch off the warning signal,
press the Alarm button 5.
Close the appliance.
Ensure that there is adequate
ventilation.
Do not exceed max. freezing
capacity.
When the fault has been eliminated,
the Alarm display goes out shortly
afterwards.
When the alarm button 5 is pressed,
the temperature display stops
flashing. Fig. 2/4
The temperature display indicates
for 5 seconds the warmest
temperature which was reached
in the freezer compartment.
Hold down alarm button 2/5 for
10 seconds until
an acknowledgement signal sounds.
After a short time check whether
your appliance is cooling.
If an acoustic signal sounds twice, your
appliance is in working order.
If the super button flashes for
10 seconds and an acoustic signal
sounds for 5 seconds, there is a fault.
Inform customer service.
Ending the appliance self-test
When the programme has ended, the
appliance switches over to normal
operation.
en
19