Lan Interface Card Configuration; Tcp/Ip Parameter Configuration - Agilent Technologies G1369C User Manual

2 Getting Started

LAN Interface Card Configuration

LAN Interface Card Configuration

TCP/IP Parameter Configuration

To operate properly in a network environment, the LAN Interface Card
must be configured with valid TCP/IP network parameters. These
parameters are:
• IP address
• Subnet Mask
• Default Gateway
The TCP/IP parameters can be configured by the following methods:
• by automatically requesting the parameters from a network- based DHCP
• by automatically requesting the parameters from a network- based
• by manually setting the parameters using Telnet
• by manually setting the parameters using the Agilent Instant Pilot
• by manually setting the parameters using the Handheld Controller
The LAN Interface Card differentiates between several initialization modes.
The initialization mode (short form 'init mode') defines how to determine
the active TCP/IP parameters after power- on. The parameters may be
derived from a Bootp cycle, non- volatile memory or initialized with known
default values. The initialization mode is selected by the configuration
switch, see
20
Server (using the so- called Dynamic Host Configuration Protocol)
BOOTP Server (using the so- called Bootstrap Protocol)
(G4208A)
(G1323A/B)
Figure 10 on page 21.
G1369C LAN Interface User Manual