Removing The Monitor Pedestal Base - HP Compaq L2311c User Manual

Removing the Monitor Pedestal Base

You can remove the monitor panel from the pedestal base to install the panel on a wall, a swing arm,
or other mounting fixture.
CAUTION:
power and signal cables are disconnected. Also disconnect all USB cables connected to the monitor.
1. Disconnect and remove all cords and cables from the monitor.
2. Lay the monitor face down on a flat surface covered by a clean, dry cloth.
3. Pivot the base 45 degrees clockwise and remove the screw from the back of the monitor, then
pivot the base 45 degrees counter-clockwise and remove the other screw from the back of the
monitor.
Figure 2-16
4. Rotate the base of the monitor up (1) then pull it back (2) to unhinge the tabs on the monitor
stand from the slots in the monitor.
Figure 2-17
Before beginning to disassemble the monitor, be sure the monitor is turned off and the
Removing the Pedestal Base Screws
Removing the Pedestal Base
Removing the Monitor Pedestal Base 17