How To Use Your Unit; How To Stop; To Use Female Tire Chuck; To Use Blow Gun - Craftsman 919.152350 Owner's Manual

How to Use Your Unit

How to Stop

:
1. Set the On/Off switch to
"OFF".
To Use Quick Connect
Coupling and Studs
1. Apply thread sealant tape
to threads of quick con-
nect coupling and studs.
2. Assemble the quick con-
nect coupling to the hose.
Attach the studs to the
blow gun and female tire chuck. Tighten securely.
This will make it easier to change over these
accessories.
3. Pull quick connect coupling back and insert stud.
See figure above.
4. Slide coupling forward to lock in place.

To Use Female Tire Chuck

1. Attach female tire chuck to hose.
2. See the "How to Start" paragraph to start air
compressor.
3. Place the female tire chuck onto the tire valve
stem of the tire to be inflated.
4. Slowly increase the pressure setting of the
adjustable pressure valve to the tire manufactur-
er's recommended PSI. Note: To ensure correct
tire pressure use a tire pressure gauge.

To Use Blow Gun

1. Attach the blow gun to hose.
If an accessory
is not being
used with the blow gun, the
safety nozzle MUST be
assembled.
2. Assemble the safety nozzle or blow gun adapter
to blow gun. See next figure.
NOTE: To use the inflating needle or tapered inflator
the blow gun adapter has to be assembled to blow
gun.
A08593
On/Off
Switch
3. Attach the inflating needle or tapered inflator to
the blow gun adapter on the blow gun.
4. See the "How to Start" paragraph to start air
compressor.
5. Depress lever on blow gun to release the air.

Before Starting:

1. Place On/Off switch to "OFF" .
2. Place the
adjustable pres-
sure valve to 10
PSI.
2. Attach hose and
accessories.
bursting. Check the manufacturer's maximum
pressure rating for air tools and accessories.
Carefully follow the "How to Start" instruc-
tions.

How to Start:

1. Place On/Off switch to "OFF" .
2. Plug the power cord into the grounded outlet.
3. Place On/Off switch to "ON" to start compressor.
4. Check the manufacturer's maximum pressure rat-
ing for the air tool, accessory, or vehicle tire being
used. The air compressor outlet pressure must
never exceed the maximum pressure rating.
5. Slowly increase the pressure setting of the
adjustable pressure valve. You should be able to
hear and feel air pressure being relieved by the
adjustable pressure valve. If pressure is not being
relieved, turn the air compressor off immediately.
The pressure valve must be replaced.
Safety Nozzle
condensation. Do not spray unfiltered air at
an item that could be damaged. Some air
operated tools or devices may require filtered
air. Read the instructions for the air tool or
device.
10 - ENG
Blow
Lever
Gun
Adapter
Too much air pressure
causes a hazardous risk of
Compressed air from the
outfit may contain water
Inflating Needle
Tapered Inflator
Safety Nozzle