Installing The Belt Clip; Installing The Cap Over The Speaker/ Microphone Jacks; Installing The Optional Speaker/ Microphone - Kenwood TK-270G Instruction Manual

■

Installing the Belt Clip

If necessary, attach the belt
clip using the two supplied
3 x 8 mm screws.
If the belt clip is not installed,
Note:
its mounting location may get hot
during continuous transmission or
when left sitting in a hot
environment.
■

Installing the Cap over the Speaker/ Microphone Jacks

If you are not using an
optional speaker/
microphone, install the
cover over the SP/MIC
jacks using the supplied
3 x 6 mm screw.
■

Installing the Optional Speaker/ Microphone

1 Insert the speaker/
microphone plugs into
the SP/MIC jacks.
2 Install the speaker/
microphone locking
bracket over the plugs
using the supplied
3 x 6 mm screw.
5