Priority Scan; Channel Lockout; Revert Channel - Kenwood TK-270G Instruction Manual

■

Priority Scan

If your dealer set up a priority channel on your
transceiver, the transceiver will continuously monitor
that channel while receiving a signal on another
channel. When a signal is received on the Priority
channel, the transceiver immediately switches to that
channel.
• "P" appears on the display.
The transceiver will remain on the Priority channel
until the signal drops out. Your dealer programs the
delay time between signal drop-out and scan
resumption.
■

Channel Lockout

If programmed by your dealer, you can select
channels to lock out of the scanning sequence.
Perform the following steps while not in Scan mode.
1 Rotate the Rotary encoder to select the channel
you want to lock out of Scan.
2 Press the key programmed as Scan Del/Add.
• Each press of Scan Del/Add toggles the lockout
status of the selected channel ON and OFF.
• Channels that are included in Scan are represented
by an "A" on the display. Channels locked out of
Scan do not have an "A" on the display.
■

Revert Channel

During Scan, pressing the PTT switch to transmit will
cause the transceiver to select the revert channel.
Your dealer programs the Revert channel for your
transceiver. Consult your dealer for details.
14