Table of Contents
Advertisement
Air Pressure
Gauge
Power Indicator
This process extracts air from the tire and replaces it with Nitrogen. Follow these steps after
the Assembly Instructions have been completed.
1.
From the Tire Inflation Unit, connect the rubber hose (with tire valve clamp) to the
tire air valve. The tire can be off or on the vehicle during this process. (If tire is left
on the vehicle, jack it up to avoid possible sidewall damage to tire.)
2.
Turn on the air compressor and set its regulator for between 130 and 140 PSI.
Tire Pressure Gauge
Tire Inflation
unit
3.
Turn the Power Switch to the On position.
•
The Power Indicator will light.
•
Check the Air Pressure Gauge for proper level.
4.
From the Tire Inflation Unit, turn the Converse Valve clockwise, and open (inline with
hose) the Air Inlet valve.
•
This step extracts the air from the tire. Inspect the tire for any leakage. Note: If this
"flats" the tire, it should be raised so rim does not damage tire.
5.
When air has been extracted, close (90° to air hose) the Air Inlet valve.
SKU 95105
OpERATING INSTRucTIONS
controls and Indicators
A - N
Generation
N
Purity Analysis
2
2
Indicator
Display
Figure E
Inflating Tires
Figure F
For technical questions, please call 1-800-444-3353
B - N
Generation
2
Indicator
Power Switch
Converse Valve
Inlet Valve
N
2
Air Inlet Valve
N
Pressure
2
Gauge
Page 9
Advertisement
Table of Contents
