Table of Contents
Advertisement
6.
From the Tire Inflation Unit, turn the Converse Valve counterclockwise, and open
(inline with hose) the N
•
This step inflates the tire with Nitrogen.
•
Check the Tire Pressure Gauge on the Tire Inflation Unit, and inflate to the tire
manufacturer's recommended tire pressure.
•
The A or B N
85 PSI.
•
Check the N
95% to 99%. If it does not, N
7.
When the tire is inflated to the proper pressure, close (90° to hose) the N
and remove the rubber hose with tire valve clamp from the tire valve.
8.
Turn the Nitrogen Generator and Inflater Power Switch to the Off position.
9.
Turn the air compressor off and disconnect the air hose from the Nitrogen Generator
and Inflater.
problem
Tire does not inflate or
deflate.
-
Power Switch on
-
Power Indicator on
N
Purity Analysis Display
2
reads less than 95%
SKU 95105
Inlet valve.
2
Generation Indicator will light. The N
2
Purity Analysis Display on the Main Unit. Purity should read between
2
supply tank may be low.
2
TROuBLESHOOTING
probable cause
1. Air or N
hoses not correctly
2
connected.
2. Air Compressor not supplying air
pressure, or not connected.
3. Not following proper operation
procedure.
4. Tire valve hose connector not
inserted properly.
Adjustment of the N 2 Purity Flow
Rate screw is required
For technical questions, please call 1-800-444-3353
Pressure Gauge should read
2
2
possible Solution
1. Review Assembly steps on
page 8.
2. Check air compressor is
on and hoses are correctly
connected.
3. Review operating procedure on
page 9.
4. Reconnect tire valve hose
connector.
Adjust the N 2 Purity Flow Rate
screw.
Inlet valve,
Page 10
Advertisement
Table of Contents
