GE GSD630 Use And Care Manual page 11

Table of Contents

Advertisement

Questions?
PROBLEM
DISHWASHER
WON'T RUN
UNUSUAL NOISE
DISHES DON'T DRY
UNCLEAN DISHES
AND FLATWARE
DETERGENT LE~
IN DISPENSER CUPS
DETERGENT CUP
LID WON'T LATCH
AFTER ADDING
DETERGENT
YELLOW OR
BROWN FILM
POSSIBLE CAUSE
A fuse in your home may be blown, or the circuit breaker tripped. Replace fuse or
reset circuit breaker. Remove any other appliances from the circuit.
Utensils may not be secure on rack pins, or something small may have dropped from
the rack. Water is causing utensils to rattle. Make sure everything is securely placed
in dishwasher.
Make sure inlet water temperature is correct. (See How To Test Water Temperature
section.)
Unload the bottom rack first. Water from dishes in the top rack may be spilling into the
bottom rack.
Check for improper loading. Dishes shouldn't nest together. Avoid overloading.
Check the rinse agent dispenser to see that it's not empty.
Check inlet water temperature. It should be at least 120°F. (To test, see How To Test
Water Temperature section.)
Water pressure may be temporarily low. Turn on a faucet. Is water coming out slower
than usual? If so, wait until pressure is normal before using your dishwasher.
Plugged air gap. (See Care and Cleaning section.)
Improper rack loading. (See Loading section.)
Water may not be reaching the detergent cups. Move dishes that may be blocking
detergent cup.
The dispenser cover may not be opening or may be blocked by improperly loaded
items. If you used a powder detergent, open the cup and remove any caked-on
detergent. If the cup still doesn't open automatically, call for service.
Detergent may be old. If the powder detergent is hard or caked in the box, throw it
away. The detergent may not be working well. Try another brand.
Cycle Indicator Dial must be in OFF position for cup lid to close and latch properly. If
you unlatch the door and open it to dry your dishes, the Cycle Indicator Dial does not
advance to OFF by itself.
Tea or coffee can stain cups. Remove the stain by hand, using a solution of 1/2 cup
bleach and 3 cups warm water.
An overall yellow or brown film on dishes or glassware can be caused by iron deposits
in water. A special filter in the water supply line is the only way to correct this problem.
Your water softener company can tell you about the filter.
Yellow film on sterling silver results when you wash copper utensils in the same load.
Silver polish will usually remove this stain.
11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gsd640

Table of Contents