GE GSD6900J10BB Installation Instructions Manual

GE GSD6900J10BB Installation Instructions Manual

Built-in dishwasher

Advertisement

Quick Links

Installation
Instructions
Built-In
Dishwasher
l If you have questions, call 800-GECARESor visit our website at: www.GEAppliances.com
I
BEFORE YOU BEGIN
Read these instructions
completely
mid carefully.
•IMPORTANT
- Ol, s e,,'e .llg,,ve,'.i.g
codes
and ordinances,
• Note
to Installer
- Be sure to leave these
instruc-
dons for the consumer's
and local inspector's
use.
• Note
to Consumer
- Keep these
instructions
with
your Owner's
Manual
for flmu'e
reterence.
Skill Level
- Installation
of this dishwasher
requires
basic mechanical
and
electrical
skills. Proper
installa-
tion is the responsibility
of the installer.
Product
failure
due to improper
installation
is not covered
under
the
GE Appliance
Waxranty.
• Completion
Time
- 1
to
3 Hours, New installations
require
more
time than replacement
installations.
•IMPORTANT
- The _lish,,'.she,
MUST _,e
installed
to alhm
tot fllture
remoxal
fl'om the enclo-
sure if serxice
is required,
If wm receixed
a damaged
dislmasher,
you should
immediateh'
contact
your dealer
O1"builder.
Optional
Accessories
- See the o,vne,"s M.n_,.1
for axailable
custom
panel
kits.
FOR YOUR SAFETY
Read
and observe
all CAUTIONS
and WARNINGS
shown
throughout
these
instructions.
While performing
installations
described
in this booklet,
gloves,
safety
glasses
or goggles
should
be worn.
READ CAREFULLY.
KEEP THESE INSTRUCTIONS.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GSD6900J10BB and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for GE GSD6900J10BB

  • Page 1 CAUTIONS and WARNINGS due to improper installation is not covered under shown throughout these instructions. While performing GE Appliance Waxranty. installations described in this booklet, gloves, safety • Completion Time 3 Hours, New installations glasses or goggles should be worn.
  • Page 2: Parts Supplied

    Installation Preparation Trim Pieces PARTS SUPPLIED: (some models) [] Two#8 Phillips flat head wood screws, 5/8" long to secure dishwasher to underside of countertop orto side of cabinetry. (Tapedto top or side of dishwasher.) [] Side and top trim pieces 2 Wood Screws 4,#8 Pan head Phillips Screws Side Mounting Brackets [] 2 Side mounting brackets with 4 mounting screws...
  • Page 3 Installation Preparation PREPARE DISHWASHER ENCLOSURE • The dishwasher must be installed so that drain hose is no more than 10 fl_et in length fin" proper drainage. • The dishwasher inust be flfllv enclosed on the top, sides and back, and must not support any part of the...
  • Page 4: Prepare Electrical Wiring

    Installation Preparation PREPARE ELECTRICAL WIRING FOR PERSONAL SAFETY: Remove house fllse or open circuit breaker before begilming installation. Do not use an extension cord or adapter phlg with this appliance. Electrical Requirements • This appliance must be supplied with 120V, 60 Hz., and Cabinet connected to an individual...
  • Page 5: Prepare Hot Water Line

    Installation Instructions PREPARE HOT WATER LINE [STEP 1] CHECK DOOR BALANCE • The line enter fl'om either side, rear or floor With dishwasher on wood skid, check the door balance within shaded area shown in Figure by opening closing the door. •...
  • Page 6: [Step 3] Remove Toekick

    Installation Instructions [STEP 3] REMOVE TOEKICK [STEP 5] INSTALL 90 ° ELBOW • Remme the mo toekick screws. • Wrap 90 ° elbow with thread seal tape. • Install a 90 ° elbow ()tat() the water xalxe. Frontof Dishwasher Remove 2 Toekick S crews FigureI 90°...
  • Page 7: Step 8] Slide Dishwasher Partially Into Cabinet

    Installation Instructions ISTEP91 INSTALL TRIM PIECES ISTEP 71 INSERT DRAIN HOSE THROUGH CABINET Skip this step if trim is not supplied with the dishwasher, • Locate trin_ strips inside dishwasher. • Upright tile dishwasher position in fl'ont of tile • Press trim onto flange...
  • Page 8 Installation Instructions • Lexel the dish- ISTEP 111 LEVEL DISHWASHER x_asher bya(!justing Access Hob IMPORTANT - Dishwasher must be level fl)r proper the flmr leveling dish rack operation and wash perfl)rmance. legs individually. • If a(!justment to the • Place level on right rear leveling door and...
  • Page 9: Drain Line Installation

    Installation Instructions [STEP 13 1CONNECT WATER SUPPLY Compression Nut Com_ect water supply line to 90 ° elbow. • Slide compression inK, then terrule over water line. • Insert water line into 90 ° elbow. • Slide ferrule against elbow secure with compres- sion...
  • Page 10: [Step 16] Pre-Test Check List

    Installation Instructions ISTEP151 [STEP 16] PRE-TEST CHECK LIST CONNECT POWER SUPPLY Review this list after installing your dishwasher avoid charges for a service call that is not covered Skip this step if equipped with power cord your warranty, Verify that power is turned off at the source, [] Check...
  • Page 11: [Step 18] Replace Toekick

    Installation Instructions ISTEP 171 DISHWASHER WET TEST [STEP 18] REPLACE TOEKICK [] Turn on power supply plug power cord into • Place toekick against the legs ol the dish_asher. outlet, if equipped). [] Latch door. [] Push "Rinse Onlv" button. [] Push start/reset pad once.
  • Page 12 _No. 3 1-30551 • No.20601559P090| SPECIFICATIONS SUBJECT T OCHANGE WITHOUT NOTICE (N.D.489) 6/02...

Table of Contents